Attach the cockpit mount: How it works

The cockpit mount allows you to securely mount your bike computer on your cockpit. You can optionally mount additional accessories using the GoPro mount supplied. We will show you step by step how to mount the cockpit mount correctly.

• 3 mm Allen key
• 2 mm Allen key
• Torque wrench
• 3 mm hex bit 

The cockpit mount is supplied with mounting screws in two different lengths. To prevent damage to the cockpit and to mount your accessories securely, always observe the screw length intended for your intended use.

• Short screws: for the cockpit mount without adapter 

• Long screws: only together with the universal adapter 

The tightening torque must not exceed 3 Nm. 

• The cockpit mount comes with two different adapter shells (inserts) for Garmin or Wahoo bike computers. Check whether the insert suitable for your device is installed. 
• Otherwise, loosen the fastening screw for the insert and replace the adapter shell. Make sure that the locknut on the opposite side does not fall out.  
• Check the correct alignment and position of the adapter shell so that your bike computer has sufficient distance from the cockpit later on.
• Screw the fastening screw back in and tighten it to a maximum torque of 1 Nm.

• If you want to fit the cockpit mount individually, insert the short screws into the mounting holes.
• If you want to use it with a universal adapter, first insert the long screws through the adapter and then into the mounting holes.
• Place the cockpit mount underneath the threaded mounts in the cockpit and then screw in the screws.
• Then tighten them to a maximum torque of 3 Nm using the torque spanner. 

• Insert your bike computer into the mount rotated 90 degrees to the left and then fix it in place by turning it to the right until you feel it click into place.
• Other accessories can be attached to the universal adapter in the usual way. Please note that the maximum load of the cockpit mount together with your bike computer must not be exceeded (max. 380 g incl. holder)